My Blog

Item Category: Vintage Electronics

  • MARANTZ 2220B VINTAGE AM/FM STEREO RECEIVER – SERVICED – CLEANED – TESTED

    WE REPLACED ALL DEFECTIVE CAPACITORS AND ANY OTHER DEFECTIVE COMPONENTS. REPAIRED ALL POOR SOLDER CONNECTIONS. INSTALLED NEW LED LAMP UPGRADE.

  • Marantz 2220B FM Front End & AM Tuner Assembly YD2888003

    Parts could fit other different Application’s and Receivers. Part will be marked to prevent part swapping. Sale is only for the part listed only. We Suggest all boards be recapped before installation regardless of condition!

  • Marantz 2220B Complete Rebuild Kit High-Quality Receiver Recap Caps Transistors

    Up for sale here is this rebuild kit for a Marantz 2220B (not the 2220). This includes all the parts you need to rebuild the Marantz 2220B P800 power supply board, P400 phono EQ board, P700 amplifier board, PE01 preamp board, and all four tuner boards, plus it includes upgraded replacement main capacitors. This does not include new lights, fuses, or output transistors. The correct replacement output transistors are two MJ21195G (replaces 2SA627) and two MJ21196G (replaces 2SD188), available here. Please do not buy any of the Chinese output transistors listed on eBay–these are counterfeit and may damage your receiver. The 2220B uses a protection relay, located on the amplifier board. There are two different versions of the 2220B–the common one uses a normal MY2 relay, and one (less common) uses a small milky-white LC2 relay. The kit does not include a relay, but I would strongly recommend replacing it. Open up your 2220B, take a look at the amp board, and figure out which relay you have. Then use “add to cart” on the kit as well as either the larger MY2 relay or the small milky-white LC2 relay. When you check out, shipping will combine automatically. This kit includes the following: P800 Power Supply kit: 6 capacitors2 double diodes1 diode2 transistors P400 Phono EQ Board:7 capacitors6 transistors P700 Amplifier Board: 10 capacitors4 transistors4 diodes (to replace two glass bead varistors) PE01 Preamp Board:13 capacitors8 transistors 4 Tuner boards: 26 capacitors2 transistors 2 new main capacitors (same diameter as the old caps so they will fit the clamps, upgraded voltage ratings)Instructions The kit for each board is bagged individually to make things easier. These are all high-quality brand new genuine parts. The main capacitors are Cornell-Dubilier 6800 uf 80v capacitors, and the other capacitors are 105° Panasonic FC, Nichicon PW, Nichicon KL, and Wima film caps at the same uf ratings and the same or higher voltage ratings. The transistors and diodes are the correct Fairchild/Onsemi subs for the original transistors. These are extremely high-quality parts, and they are what I use when I rebuild Marantz equipment. I will include surprisingly well-written instructions, but rebuilding a receiver is moderately complicated, and you should know what you’re doing and have a decent soldering iron, heat-sink compound, and a dim-bulb tester with a 60W or 100W incandescent bulb. Please see my pictures for details. US shipping and handling is $10, and international is $28. If you have any questions, please ask. Looking for more parts? I have power switches, feet, pushbuttons, top case screws, bottom screws, faceplate screws, white LED fuse lamps, blue LED fuse lamps, 6.3v bi-pin bulbs, 8v bi-pin bulbs, 12v bi-pin bulbs, wired 8v 60ma bulbs, new power cords, new main capacitors for the Marantz 1060/2230, wired Pioneer speaker plug replacements, new 630v yellow film capacitors at 30 different values, a large variety of transistors for vintage stereo repair, new 250v yellow film crossover capacitors, and more. Just use “add to cart” on everything you want and then check out for combined shipping.

  • Marantz 2220B AM/FM Stereo Receiver 20 WPC Open Box perfect working condition

    Channel separation: 35dB (line). Power output: 20 watts per channel into 8Ω (stereo). Input sensitivity: 1.8mV (MM), 180mV (line). Frequency response: 10Hz to 50kHz. Signal to noise ratio: 77dB (line).

  • Marantz Model 2220B Stereo Receiver *READ*

    Review all pictures as what you see is what you will get! Working conditions ! This item is.

  • vintage marantz 2220b stereo receiver

    vintage marantz 2220b stereo receiver. Condition is Used. Shipped with USPS Ground Advantage.

  • Marantz 2215B 2216 2220B Light Replacement Kit 360° Blue LEDs Lamp Bulbs

    Up for sale here is this complete replacement lighting set for the Marantz 2215B, 2216, or 2220B. You will receive:Six (6) snap-in 360° cool blue LED fuse lamps (for the tuning dial and meter)Two (2) wired 8v 50ma 4mm incandescent bulbs for the FM stereo light and tuning needle These are top-quality bulbs, and are the exact same ones I use when I rebuild Marantz gear. These are top-of-the-line lights–I love using them! The new 360° fuse lamps are WAY better than the regular 3-LED fuse lamps. You will need a soldering iron, wire cutters, needlenose pliers, and a Philips screwdriver. Be very careful not to damage the tuning dial cord when you’re soldering! If you wrap the dial cord in aluminum foil ahead of time, that will help protect it. If you want this kit with white snap-in LED fuse lamps instead, I have that kit available here. I have kits for most other Marantz gear listed, just take a look at my other listings. Please see my pictures for details. US shipping and handling is $5, and international is $18, no matter what quantity you buy. All my small parts are set up for combined shipping, so just use the “add to cart” feature and then check out all at once, and it will combine shipping. If you have any questions, please ask. Looking for more parts? I have power switches, feet, pushbuttons, top case screws, bottom screws, faceplate screws, white LED fuse lamps, blue LED fuse lamps, 6.3v bi-pin bulbs, 8v bi-pin bulbs, 12v bi-pin bulbs, wired 8v 50ma bulbs, new power cords, new main capacitors for the Marantz 1060/2230, wired Pioneer speaker plug replacements, new 630v yellow film capacitors at 38 different values, new 1200v yellow film capacitors at 15 values, a large variety of transistors for vintage stereo repair, new Wima film capacitors for stereo repair, new 250v yellow film crossover capacitors, and more. Just use “add to cart” on everything you want and then check out for combined shipping.

  • Marantz 2220B receiver rebuild restoration recap service capacitor kit repair

    We also offer NEW production volume control ———–> LINK The scarcity of good, honest techs who can do good and reasonably priced restoration/rebuild of audio equipment inspired me to create this restoration kit. In today’s day and age, it is difficult to find a knowledgeable technician who can service your audio gear properly. I have seen many poor quality restorations of equipment that cost way too much for their owners. In 99% of the cases, only a few parts were replaced, instead of a full and proper restoration job.A proper restoration must replace all electrolytic capacitors on all boards. Do not fall for partial kits that restore just one PCB (power supply, power amp, etc.). This is not a good or proper way to restore your audio equipment. It is the same as with car tires; one should never replace just one tire and keep the other worn-out tires on. A proper rebuild requires a full recap of all PCBs.On the other hand, if one succeeds in finding a good tech, the wait time is usually 6-12 months for the unit to be serviced, and costs are sky-high. I have been servicing audio equipment for many years and have developed deep respect for all good equipment. Knowing how amazing and warm these units can sound, I decided to put together this kit. It includes very good upgrades and improvements that must be done to the unit. This restoration kit will make a huge difference in the sound quality. All the parts are of high-quality Japanese Nichicon / Rubycon / IC / United Chemi capacitors.I am extremely particular about the quality of the parts provided in this kit. Knowing how many bogus/fake caps, diodes, resistors, etc. are out there, I source all the parts from reputable wholesalers and buy them in bulk. Vintage audio equipment has the potential to deliver rich and authentic sound when it is properly restored. Not only can it enhance your listening experience, but it can also evoke memories and bring joy to your life. Let’s work together to bring your vintage gear back to its full potential, and make sure you have the music you deserve. ♩♬♫♪♫♩♬ “They Shall Have Music”- Avery FisherIncluded in this kit: 1. Power/Filter stage capacitors (Nichicon / Nippon / United Chemi) electrolytic capacitors. 2. Detailed instruction with colorful images, schematics, manuals (all of these are in electronic form, I consider these much better than printed version due to zoom availability). 3. Schematics 4. Complete audio path upgrade with high quality US made (IC) or Nippon audio grade film capacitors. 5. Parts for compete recap of all the electrolytic capacitors. 6. Complete recap of all PCBs. 7. Transistors (PNP, NPN). 8. fuse/s 9. Instructions on how to clean the chassis. 10. Instructions on how to clean a faceplate 11. Instructions on how to polish knob covers. 12. Support/help to a reasonable extend in case you need it. (This is what makes us different from other sellers.) Also available LED convertion kit ———–> LINK NEW production volume control ———–> LINK We also offer a great selection of Restoration Kits, LED conversion kits, Volume Controls, Rotary Switches and other rare/unique parts;Make sure to check our store ———> LINK (Use the search bar inside the shop to find what you need faster)We may also be interested in purchasing your equipment

  • Marantz 2220B receiver replacement LED bulb lamp light set upgrade kit

    We also offer FULL restoration kitSee the ———–> LINK As someone who has serviced many various vintage audio equipment for a considerable amount of time, I have developed a deep admiration for good quality gear. However, I have noticed that many of these units suffer from constantly failing incandescent bulbs, resulting in wasted money on services to replace them time and time again. After years of dealing with this issue, I decided to take matters into my own hands and develop an LED replacement that would match the color temperature and angle of the light. Through my research and collaboration with a manufacturer of LED bulbs, I was able to develop a perfect replacement that not only matches the color temperature but also offers a 360-degree lighting angle compared to the 120-degree angle of regular LED bulbs. This LED replacement has the correct voltage and is sure to save users time and money in the long run. I am thrilled with the results of my efforts and confident that this LED replacement will be a game-changer. Say goodbye to constantly replacing incandescent bulbs and hello to the reliable and efficient lighting of LED technology. These are frosted lens bulbs. The frosted lens allows much wider and even light distribution compared to a clear lens. There is no halo effect with the frosted lens. – 6 x Warm white 8v fuse type LED/ – 7 x LED bi-pin 8V bulbs. (Much superior in comparison to the original incandescent bulbs. These do not produce any heat, heat that damages internal filters and boards.) – 1 x 8V indicator wired LED bulb. – Installation instructions (either video or Word file presented electronically) Also available NEW production volume control —–> LINK FULL restoration kit See the —-> LINK We also offer a great selection of Restoration Kits, LED conversion kits, Volume Controls, Rotary Switches and other rare/unique parts;Make sure to check our store ———> LINK (Use the search bar inside the shop to find what you need faster)We may also be interested in purchasing your equipment

  • Marantz 2220B Stereo Receiver – Serviced – See Listing

    The faceplate and glass are clean and have minimal marks, the woodgrain vinyl cabinet is in very nice condition as well, SEE PICS. Power output: 20 watts per channel into 8Ω (stereo). We hand test or power on to test used products to ensure functionality.