Recone kit for the Cerwin Vega E312 CWV12. Red over gray foam like original. Kits include everything in the picture. Shims available on request. Also included is a sheet of tips and suggestions from decades of experience, along with my personal phone number should you have an issue. If you have any questions, or want a specific bunch of parts put together for you, let me know. I’m here to help and happy to put together any combination of parts you need. 22 years on Ebay, selling mostly speaker related stuff, and mostly Cerwin Vega, with 100% positive feedback. Will be packed securely and shipped promptly. Thanks!
Item Category: Vintage Electronics
-
Cerwin Vega 15″ Speaker Foam Surround Repair Kit DX9 RE38 VS15- MX400 UK ship
These foams are designed for refoaming the angle attach cones that used the thin lip flat attach foam. These foams are not for the flat attach cones, the ones that have the flat lip on the edge of the cone, like the D9.
-
15″ 4 Ohm Recone Kit for Cerwin Vega W15-4 380SE 380-SE CD90 Correct cone
Recone kit for the Cerwin Vega W15-4 woofer used in the 380SE, CD90 and probably others. These were developed specifically, exactly, for this woofer. Ribbed cone like the original and pleated accordion surrounds. Precision voice coils, on ALUMINUM formers like the originals. Several years, and more recones than I can count went into developing these to provide kits that not only take the pounding that I know you’re going to give them, but also match the t/s parameters of the originals. These kits are different from the other kits available in several ways. All the other kits I have seen, use the 5H2040 cones. Those cones were originally developed for the eh series woofers, which were very different. They used a smaller spider which sat down inside the typically used landing, so those 5h2040 cones at 3.825 deep, are too deep to sit properly when using the correct spider. Also, since those EH series woofers were used as a midbass in sound reinforcement tops, those cones are extremely thin and light. About 26 grams, which is half of the original W15-P cone weight. Plus the surround ribbing has much shallower ribs, limiting excursion. These new Brew City kits solve all those issues. A close look at the surround, and comparing these to the originals, and the other kits out there, will tell the story. Plus these are much stiffer, and weigh in at 52g. The only drawback to these, is that the ribbing doesn’t go down the cone quite as far, which could not be avoided. Most spec sheets specify a 3.75″ dustcap which is included, however I have seen many of these woofers original with a 4.5″ dustcap, so if you want the wider cap instead, just let me know and I’ll pack those for you. COIL OPTION: I have the specs for the coils originally spec’d for these woofers, which are a somewhat common 2-layer coil, also used in the D9. BUT, upon tearing down several W15-4 woofers, I have found that the coil gap is wider than called for, and big enough to accept the thicker wound DLP coils used in a few other woofers like the DX9 woofer. All things being equal, I think that DLP coil would be the preferred one to use. Since Cerwin (And Heppner) were notorious for making running design changes, I don’t know if all W15-4 motors had the wider gap. So, these kits will include the standard coil specified for W15-4 woofer, but if you want to send me a picture of the coil gap, so we can verify which one you have, I’d be happy to substitute the thicker DLP coil in your kits if you want them. Kits include everything in the picture. Shims available on request. Also included is a sheet of tips and suggestions from decades of experience, along with my personal phone number should you have an issue. If you have any questions, or want a specific bunch of parts put together for you, let me know. I’m here to help and happy to put together any combination of parts you need. 20+ years on Ebay, selling mostly speaker related stuff, and mostly Cerwin Vega, with 100% positive feedback. Will be packed securely and shipped promptly. Thanks!
-
10″ Recone Kit for Cerwin Vega RE25 RE-25 REW10 W10-4 4 ohms
10″ 4 ohm recone lit for the models listed. Kits include everything in the picture including 4 piece shim kit which allows accurate shimming of any coil. It is a slight color/dot distortion from the mold.
-
Cerwin Vega 12″ Speaker Foam Surround Repair Kit AT VS D DX LS Angle
These foams are slightly different, and done that way by painstaking research and design. If you’re familiar with refoaming Cerwins, you’ve undoubtedly seen where the ID of the foam is just slightly too large, so when you’re done, you can see a little of the old glue ring inside your new foam, leaving a sloppy look.
-
15″ DVC! Dual 4 ohm recone kit for Cerwin Vega DCW15 DC15 1515
These are the correct DUAL VOICE COIL recone kits for the DCW15 woofer used in the DC15 and 1515 Cerwin Vega speakers. The “DC” in the name actually referenced the fact that the woofers were dual voice coil, and the crossovers actually split the signal and ran different frequencies to each coil. Up till now, all the kits listed for these woofers all used the DLP (dual lead parallel coils, which are different. DLP coils and only have one set of leads. These have dual sets of leads to recone and re-hook up properly. These have the older style red/red foams but are in perfect shape. I came across a large number of old stock recone kits for Cerwin Vega. Strokers, 18″ woofers, and misc. Most of these are pre-2010. Kits have changed over the years, and not always for the better. I’ll be listing everything including some tasty rare bits over the next few weeks. If you have any questions, I’m always here and happy to help. Over 20 years here on ebay, selling mostly Cerwin Vega woofers, parts, and kits, with 100% positive feedback. I pack securely and ship promptly. Thanks!
-
10″ Recone Kit for Cerwin Vega 101W2 101W3 10W2 D2 D3 D4 LS10 LS-10 8 ohms
10″ 8 ohm recone lit for the models listed. Kits include everything in the picture including 4 piece shim kit which allows accurate shimming of any coil. It is a slight color/dot distortion from the mold.
-
10″ Recone Kit for Cerwin Vega woofer 101-2 L101-2 D3 8 ohms
10″ 8 ohm recone lit for the models listed. Kits include everything in the picture including 4 piece shim kit which allows accurate shimming of any coil. It is a slight color/dot distortion from the mold.
-
15″ 4 Ohm Recone Kit for Cerwin Vega ATW-15 ATW15 (At-15) woofer ribbed cone
Recone kit for the Cerwin Vega ATW-15. These were developed specifically, exactly, for this woofer. Lightweight ribbed cone like the original. Red over gray foam like original. All new high precision voice coils, on ALUMINUM formers like the originals, and DLP wound like the originals. (DLP is dual lead parallel) Several years, and more recones than I can count went into developing these to provide kits that not only take the pounding that I know you’re going to give them, but also match the t/s parameters of the originals. Kits include everything in the picture. Shims available on request. Second picture shows a woofer reconed with this kit. (woofer not included) Also included is a sheet of tips and suggestions from decades of experience, along with my personal phone number should you have an issue. If you have any questions, or want a specific bunch of parts put together for you, let me know. I’m here to help and happy to put together any combination of parts you need. 19 years on Ebay, selling mostly speaker related stuff, and mostly Cerwin Vega, with 100% positive feedback. Will be packed securely and shipped promptly. Thanks!