Item Tag: TRANSISTORS

Up for sale here is this complete rebuild kit for the Marantz 1060 amplifier. This includes all the parts you need to rebuild the Marantz 1060 power supply board, amplifier board, phono EQ board, and preamp board, plus it includes upgraded replacement main capacitors, a new blue LED, and a new power switch with snubber capacitor. This does not include new fuses or output transistors. The correct replacements for the original output transistors are MJ21196G, which I have available here. Please do not buy any of the Chinese transistors listed on eBay–these are counterfeit and will damage your amp. This kit includes the following: Power Supply Board: 4 capacitors2 diodes1 transistor Amplifier Board:12 capacitors6 transistors4 trimmers2 diodes Phono EQ Board: 7 capacitors6 transistors Preamp Board:13 capacitors8 transistors 3 new main capacitors (2 are same diameter as the old caps so they will fit the clamps, upgraded uf/voltage rating)1 mounting clamp (for third cap to replace giant capacitor)Power switch w/ snubber capacitor & knob Wired blue LED (I can substitute an incandescent bulb if you prefer, just let me know) Instructions The kit for each board is bagged individually to make things easier. These are all high-quality brand new genuine parts. The main capacitors are one Nichicon LS 6800 uf 80v cap and two Epcos 3300 uf 100v caps, the other capacitors are 105° Panasonic FC, Nichicon PW, Nichicon KL, and Wima film caps at the same uf ratings and the same or higher voltage ratings, and the transistors and diodes are the correct Fairchild/Onsemi subs for the original transistors. These are extremely high-quality parts, the same ones I use when I rebuild Marantz equipment. The two smaller main caps have drop-in replacements, but the third giant one (on the right) is replaced with a physically smaller cap plus a new clamp to mount it properly. The chassis has screw holes already there for this new cap–you will need to provide two small sheet-metal screws to mount it, plus reuse the nut/bolt from the old clamp. The 100 uf capacitors on the preamp and phono boards are upgraded to 220 uf caps, for more filtering and better sound. I will include surprisingly well-written instructions, but this is a moderately complicated job, and you should know what you’re doing and have a decent soldering iron and a dim-bulb tester with a 40W, 60W, or 100W incandescent bulb. US shipping and handling is $10, and international is $28. If you have any questions, please ask. Looking for more parts? I have power switches, feet, pushbuttons, top case screws, bottom screws, faceplate screws, white LED fuse lamps, blue LED fuse lamps, 6.3v bi-pin bulbs, 8v bi-pin bulbs, 12v bi-pin bulbs, wired 8v 60ma bulbs, new power cords, new main capacitors for the Marantz 1060/2230, wired Pioneer speaker plug replacements, new 630v yellow film capacitors at 13 different values, a large variety of transistors for vintage stereo repair, and more. Just use “add to cart” on everything you want and then check out for combined shipping.